Comparing Bond Strength,Microleakage and Clinical Performance of Three Pit and Fissure Sealants

Sarah Emad Ali El-Din

Status: Unknown

Conditions: Caries Prevention

Treatments: Other: Triage sealant; Other: Embrace wetbond sealant; Other: Clinpro sealant

Study type: Interventional

Funder types: Other

Identifiers

NCT04272866

PED 18-9M

Details and patient eligibility

About

The aim of the study is :-

1. To evaluate and compare the microleakage of three different fissure sealants(resin-based Clinpro sealant, Moisture tolerant resin-based Embrace WetBond sealant and glass ionomer Fuji Triage sealant) in vitro.
2. To evaluate and compare the bond strength of three different fissure sealants(resin-based Clinpro sealant, Moisture tolerant resin-based Embrace WetBond sealant and glass ionomer Fuji Triage sealant) in vitro.
3. To clinically evaluate and compare the retention of three different fissure sealants(resin-based Clinpro sealant, Moisture tolerant resin-based Embrace WetBond sealant and glass ionomer-based Fuji Triage sealant).
4. To clinically evaluate and compare the caries prevention effect of three different fissure sealants(resin-based Clinpro sealant, Moisture tolerant resin-based Embrace WetBond sealant and glass ionomer-based Fuji Triage sealant).

Full description

Total of 60 first permanent molar in male and female children aged between 6-9 years included in this prospective study will be selected randomly from the outpatient Pediatric Dentistry and Dental Public Health Department Faculty of Dentistry Ain Shams University.

Informed consent will be signed for each case by the patient's parent or guardian after thorough explanation of the study.

Procedural Steps:

In vivo

1. Teeth will be divided equally into 3 groups randomly according to the type of sealant used.
2. Pit and fissure sealant application will be conducted by a single operator.
3. A thorough oral prophylaxis of both upper and lower arches was done, followed by polishing using a slurry of pumice and rotating brush to ensure removal of debris from fissures.
4. The occlusal surfaces were then thoroughly cleaned with water to remove all traces of pumice. Isolation of permanent first molars will be obtained using cotton rolls and a saliva ejector.

Group 1(Clinpro sealant)Active control

1. The occlusal surface will be dried and etched with 37% phosphoric acid gel for 30 s
2. Thorough rinsing for 30 s using an oil-free air-water syringe.
3. Clinpro™ Sealant then applied with the brush applicator and light cured for 20 s using visible light cure unit.

Group 2(Embrace WetBond sealant)

1. Etching the teeth for 15 seconds with a phosphoric-acid etchant.
2. Then rinse the etchant from the teeth with an air-water spray for 10 seconds,
3. followed by very light drying of the treated surfaces. With Embrace Wet-Bond, the typical dull, frosted appearance of the etched surface is not desired. Rather, the surface should be lightly dried and very slightly moist with a glossy appearance. To accomplish this, a cotton pellet should be used to remove the excess moisture There should be no visible pooling or drops of water on the tooth surfaces.
4. Applying the Embrace WetBond sealant to the occlusal surface using the supplied applicator tip After dispensing, use a brush applicator to place the sealant, covering all pits and fissures and extending onto the cusp ridges. The final sealant thickness upon application should be at least 0.3 mm.
5. After application, light-cure the sealant for 10 seconds, holding the light-curing probe at right angles to the occlusal surface as close as possible using a high-intensity curing light.

Group 3 (Fuji Triage sealant)

1. The occlusal surfaces conditioned with Dentin Conditioner for 20 s and then rinsed for another 20 s, followed by drying by blotting with a cotton pellet and gently blowing with an air syringe. The surfaces appeared moist and not desiccated.
2. Fuji Triage sealant will then applied to the occlusal surface using a plastic-filling instrument and a disposable nylon brush to spread it into the pits and fissures.
3. The material is self-curing, but a light-curing device can be used for 20 to 40 seconds to hasten setting.
4. When the material loses its glossy appearance, one drop of Fuji Coat is dispensed The coating is applied with a brush to the treated surface and adjacent areas, and light curing is applied .

Articulating paper was used to check the occlusion and any premature contacts were adjusted. The patients were instructed not to eat or drink anything for 30 min, and not to bite or chew on hard substances for the rest of the day. The patients were recalled after a time interval of 1 and 6 months to evaluate the retention and development of caries using Modified Simonsen's criteria.

Criteria for evaluation: (Modified simonsen's criteria) Score 0: No loss of sealant and no evidence of caries Score 1: Partial loss of sealant and no evidence of caries Score 2: Partial loss of sealant and evidence of caries. Score 3: Complete loss of sealant and no evidence of caries Score 4: Complete loss of sealant and evidence of caries. On recall at 3 and 6th month interval, the sealants were evaluated by visual and tactile examination with a sharp probe for retention. The teeth were visually inspected for caries. The data obtained were tabulated and subjected to statistical analysis.

Enrollment: 100 patients

Sex: All

Ages: 6 to 9 years old

Volunteers: Accepts Healthy Volunteers

Inclusion criteria

• 1- First permanent molars fully erupted with deep and retentive fissures,free of caries and free of any periapical radiolucency.

  2- Males and Females 3- Age group between 6-9 years 4- Medically free 5- High caries risk children

Exclusion criteria

1. Medically compromised children
2. Uncooperative children.
3. Children with abnormalities in occlusion
4. children with abnormal oral habits

Trial design

Primary purpose: Prevention

Allocation: Randomized

Interventional model: Factorial Assignment

Masking: Single Blind

---

100 participants in 3 patient groups

Group 1

Active Comparator group

Description:

Teeth in this group will be sealed with clinpro sealant

Treatment:

Other: Clinpro sealant

Group2

Experimental group

Description:

Teeth in this group will be sealed with embrace wetbond sealant

Treatment:

Other: Embrace wetbond sealant

Group3

Experimental group

Description:

Teeth in this group will be sealed with triage sealant

Treatment:

Other: Triage sealant