Status
Conditions
Treatments
About
The present study is a monocentric, observational, single arm, study, with the aim to determinate the ability of FFR-CT to exclude or confirm the presence of hemodynamically significant coronary stenosis, compared to coronary angiography in high-risk acute coronary syndrome patients.
Full description
Study Design and Procedure:
The present study is a single arm, double blinded, prospective trial. Patients admitted to hospital with high-risk non-ST elevation acute coronary syndrome (NSTE-ACS) and who accept to participate to the study will undergo a coronary compute tomography (CT) angiography within 23 hours after diagnosis in order to have time to proceed to coronary angiography within the recommended window time of 24h. After realization of the CT, they will benefit from guidelines recommended treatment including a coronary angiography. According to internal and international guidelines, all efforts will be made to perform the coronary angiography within 24h of acute coronary syndrome (ACS) diagnosis.
The coronary CT angiography procedure takes approximately 1-2h (including logistical organization and patient transportation), and all efforts will be made not to delay the coronary angiography compared to patients who would not participate in the study. At the time of coronary angiography, patients will be blinded from the CT results as well as the direct treating physician and interventional cardiologist realizing the procedure, in order to avoid any influence in patients' management. The procedure will be done using a 256-slice multi-detector CT (GE Healthcare Revolution CT, Chicago, Illinois, USA). Just before the examination, as routinely done for this non-invasive test to allow for optimal coronary vasodilation and visualization, oral Metoprolol (25-50mg) will be administered if necessary to ensure a heart rate of 65 bpm or lower as well as one unique dose of sublingual nitroglycerine (400-800mg). Parameters used for CT acquisition will be as following: 100 Kilovoltage peak (kVp)/550 milliamperes (mA) for body mass index (BMI) <25 (high definition mode), 100 kVp/550 mA for BMI included between 25 and 30, 120 kVp/600 mA for BMI>30 (standard definition mode). Off line, an FFR-CT will be calculated with the data of the coronary CT angiography by blinded investigators in a central FFR-CT core laboratory (HeartFlow ®, Redwood City, CA 94063, USA). Hemodynamically significant lesion will be defined as lesion with an FFR-CT value of ≤ 0.80.
During the invasive coronary angiography, fractional flow reserve (FFR) will be measured in all lesions with a visual diameter stenosis ≥30% using the PressureWire™ X Guidewire (Abbott, Chicago, Illinois, USA) with the following protocol: first, equalization of the pressure wire and the aortic pressure will be performed at the tip of the guide catheter prior to all measurements. Second, the pressure wire will then be advanced distal to the stenosis. Third, hyperemia will be obtained using intracoronary adenosine (150mcg for the right coronary artery and 200mcg for the left descending or the circumflex coronary arteries). Fourth, at the end of the procedure, the absence of a drift will be confirmed after a pull-back of the pressure to the same location as the initial equalization. Hemodynamically significant lesion will be defined as lesion with an FFR value of ≤ 0.80.
Of note, in case of coronary angiography showing no obstructive coronary disease, and thus not offering satisfactory explanation for the myocardial injury, patients will undergo cardiac magnetic resonance imaging (CMRI), to detect a potential alternative diagnosis (myocarditis, Takotsubo...).
Both invasive FFR and FFR derived from FFR-CT will be compared with invasive FFR as gold standard.
Follow-up:
Follow-up will be organized 1 month (± 7 days), 6 months (± 14 days) and 12 months (± 14 days) after the acute coronary syndrome. These visits will include a detailed history, as well as physical examination and ECG. During the second visit, a transthoracic echocardiography will be performed, and a treadmill exercise stress test will be performed during the third visit.
Data and Statistical Analysis:
Statistical analysis will be carried out using SPSS 24.0 software (SPSS Inc., Chicago, Illinois) and Stata 14.3. Comparisons of characteristics of patients will be performed using Chi-squared tests for qualitative variables and Student's t or Mann-Whitney tests as appropriate. Confidence intervals (CI) for proportions (sensitivity, specificity, accuracy) will be calculated using the Wilson Score method. With the last iteration of the FFR-CT software, the per-patient sensitivity and specificity were 86% (95% CI: 77% to 92%) and 79% (95% CI: 72% to 84%). In the recent VERDICT trial based on NSTEMI patients, 12 % had 3 vessel disease, 23 % 2 vessel disease (which included left main), 34%, 1 vessel disease, 30% nothing, Thus, out of 100 patients with 300 coronaries, we expect 106 (i.e. 36+46+34) vessels with a stenosis. Based on the FAMOUS NSTEMI trial, 60% of invasive FFR measurements of these stenoses were significant. Thus, with a standard error of 0,05, and for a power of 80%, 204 patients will be required. However, some of the CT will not be suitable for analysis and some patients will have to be excluded. Therefore, we plan to include 250 patients. Of note, these number is also in line with the literature investigating the accuracy of FFR-CT versus FFR in patients with stable coronary artery disease.
Enrollment
Sex
Ages
Volunteers
Inclusion criteria
Exclusion criteria
164 participants in 1 patient group
Loading...
Central trial contact
Stephane Fournier, MD; David Meier, MD
Data sourced from clinicaltrials.gov
Clinical trials
Research sites
Resources
Legal