One Year Clinical Performance of Self Adhesive Giomer Containing Flowable Composite in Restoring Class V Cavities

Cairo University (CU)

Status: Unknown

Conditions: Class V Dental Caries; Composite Resin and Self Adhesive Flowable Composite

Treatments: Other: (FIT SA F03, SHOFU, USA); Other: (Neo Spectra™ ST, Dentsply, Sirona, USA)

Study type: Interventional

Funder types: Other

Identifiers

NCT04944485

14422019423506

Details and patient eligibility

About

This clinical trial will be conducted to compare the clinical performance of self adhesive giomer containing flowable composite and putty nanohybrid resin composite in class V cavities over one year follow-up

Full description

This clinical trial will be conducted in Department of Conservative Dentistry, Faculty of Dentistry,Cairo university outpatient clinic. The Operator in charge will be: Salma Mohamed Monir (S.M).

The researcher will bear ultimate responsibility for all activities associated with the conduct of a research project including recruitment of patients, explaining and performing the procedures to the patients.

Screening of patients that come to the Conservative Dentistry Department Clinic seeking dental care will continue until the target population is achieved. The patients will be subjected to full examination and diagnosis using dental charts. Once the patients that are potentially eligible for this study are identified, the patients will be contacted by the research investigator (S.M) who will explain the study and ascertains the patient's interest. If interested, more detailed evaluations and preparations are made.

Randomization will be done using simple randomization by (N.K) by generating numbers from 1:100 into two columns according to interventions/Control assessment methods. The allocation sequence will be generated using (www.randomization.com) The randomization list will be kept with (N.K) and will be kept secured away to ensure no tampering with the random list. Each participant will choose a random number from an opaque sealed envelope. When the participant chooses an envelope, it will be signed by the patient and the supervisor and the number on the envelope will be recorded in the patient chart to ensure that the patient is assigned to the randomized group The assessors, statistician and the patients will be blinded to intervention/control assessment methods; Triple blinded study. Also, it will not be allowed amongst the examiners to exchange any information throughout the entire study period.

For every patient medical and dental history will be taken. Examination charts will be filled by the investigator S.M.

Informed consent:

Patients attending at the Department of Conservative Dentistry, Faculty of Dentistry, Cairo University will be screened. Those who meet the study inclusion criteria will be recruited, will be informed with the study and an informed consent will be signed if the patients approve.

Periodontal treatment:

Periodontal treatment will be made and oral hygiene instructions will be enforced. Then, the operator will start rubber-dam isolation and cavity preparation is done as follows:

Cavity preparation procedure:

Patients will be given local anesthesia as required, and the teeth will be isolated. A No. #330 bur (0.8 mm in diameter and 1.6 mm in length) in a high speed hand piece with air /water coolant will be used to prepare class V cavity preparations. Any tooth that will suffer from pulpal exposure will be excluded from the study. Remaining caries will be excavated by a sharp excavator. A 1mm bevel will be prepared in enamel margins (Folwaczny et al., 2001). According to the concealed envelope, the tooth will be assigned to one of both treatment groups.

Control group: Selective enamel etching will be done and a universal adhesive (Prime&Bond universal™ ,Dentsply)will be applied to both enamel and dentin. After gentle dryness and solvent evaporation the bonding agent will be cured for 20 seconds. Composite (Neo Spectra™ST, Dentsply, Sirona, USA) will be placed incrementally and light cured for 20 seconds (Noé Orellana et al., 2009)

Intervention group: Cleaning and gentle air blowing of the preparation. Then applying FIT SA F03 (Low Flow), SHOFU, USA. Spread in a thin layer (≤0.5mm) on the prepared surface with needle tip, microbrush and gently air-blow leave for 20 seconds then light cure for 5 seconds. Then, apply additional increments (≤2mm) of FIT SA and light cure each increment for 10 seconds then finish and polish.

Post curing will be done using glycerin to decrease the oxygen inhibited layer (Strnad et al.,2015). Finishing will be done using yellow and white finishing stones. More finishing and polishing will be done. Rubber-dam will be removed and patients will be recalled for evaluation after 3, 6 and 12 months. A.R and Y.S will be blinded to both treatment groups. AR and Y.S will give the restorations a score using Modified USPHS score.

Enrollment: 46 estimated patients

Sex: All

Volunteers: No Healthy Volunteers

Inclusion criteria

1. Patients with carious anterior or posterior buccal class V lesions.
2. No signs of irreversible pulpitis (vital teeth)
3. Young adult males or females.
4. . Acceptable oral hygiene.
5. Co-operative patients approving to participate in the study

Exclusion criteria

1. Patients with a compromised medical history.
2. Severe or active periodontal disease
3. Systemic diseases or severe medical complications (disabilities).
4. Lack of compliance
5. Extensive carious lesion that is in risk of pulp exposure.
6. Rampant caries.
7. History of pain or swelling.
8. Endodontically treated teeth.
9. Mobility grade 1 or 2
10. Non-carious cervical abfraction lesions

Trial design

Primary purpose: Treatment

Allocation: Randomized

Interventional model: Parallel Assignment

Masking: Double Blind

---

46 participants in 2 patient groups

class V cavities treated with putty nanohybrid resin composite

Active Comparator group

Description:

Selective enamel etching will be done and a universal adhesive (Prime\&Bond universal™ ,Dentsply)will be applied to both enamel and dentin. After gentle dryness and solvent evaporation the bonding agent will be cured for 20 seconds. Composite (Neo Spectra™ST, Dentsply, Sirona, USA) will be placed incrementally and light cured for 20 seconds

Treatment:

Other: (Neo Spectra™ ST, Dentsply, Sirona, USA)

class V cavities treated with Self adhesive giomer containing nanohybrid flowable composite

Experimental group

Description:

Cleaning and gentle air blowing of the preparation. Then applying FIT SA F03 (Low Flow), SHOFU, USA. Spread in a thin layer (≤0.5mm) on the prepared surface with needle tip, microbrush and gently air-blow leave for 20 seconds then light cure for 5 seconds. Then,apply additional increments (≤2mm) of FIT SA and light cure each increment for 10 seconds then finish and polish

Treatment:

Other: (FIT SA F03, SHOFU, USA)