Patient Satisfaction in Single Implant Mandibular Complete Overdentures Retained by CM LOC Versus Ball Attachment

Cairo University (CU)

Status: Unknown

Conditions: Dental Implant; Edentulous

Treatments: Device: CM LOC; Device: ball attachment

Study type: Interventional

Funder types: Other

Identifiers

NCT02923661

CEBD-CU-2016-09-205

Details and patient eligibility

About

this study was conducted to clarify the effect of two different attachments on patient satisfaction and marginal bone loss. The primary and secondary objectives are to determine patient satisfaction and the marginal bone loss around implant when using CM LOC compared to conventional ball attachment. all the patients will receive a single median implant to which the denture will be loaded upon using the two different attachment systems

Enrollment: 40 estimated patients

Sex: All

Ages: 50 to 69 years old

Volunteers: Accepts Healthy Volunteers

Inclusion criteria

• Completely edentulous male or female patients between the ages of 50 to 69.
• No contraindications for implantation.
• Each patient has to perform both a random blood sugar and Glycosylated Hemoglobin analysis. Patients with a Glycosylated hemoglobin test HbA1c up to 8% and a normal blood sugar level (79 to 110) or controlled diabetic patients (90-130 fasting according to American Association of Diabetes) will be included.
• Sufficient bone width (≥ 6 mm) in the anterior region to place an implant. It could be either normally present or achieved by bone plateauing. This will be confirmed by cone beam computed tomographic (CBCT) scans.
• Residual bone height ranging from 11-20 mm with the lowest vertical height in the midline of the mandible not less than 13 mm (Class II or III according to McGarry et al.22This will be confirmed by the CBCT.
• Patients seeking to install a single symphyseal implant and for whom new dentures will be constructed.
• Patients, who are dissatisfied with the retention and stability of their technically satisfactory dentures.
• Patients, who already have existing maxillary and mandibular complete dentures, and after examination of the mandibular dentures, it is found that there are technical problems with regard to denture design and/or occlusion; then new maxillary and mandibular dentures will be fabricated
• All patients should have adapted to their dentures for at least six weeks before being included in the trial.
• Patients providing written informed consents to participate in the trial and this will be done before the scheduled date for implant installation.

Exclusion criteria

• Patients with a systemic or local contra-indication for implant placement.
• Satisfied patients with the retention of their mandibular denture as well as unsatisfied patients with their maxillary denture.
• Patient with a mandibular denture height less than 6 mm between the base of the denture and the incisal edge of the central incisors (as measured by a caliper) or with 12 mm crown height space as measured by a ruler from the incisal edge till the crest of the ridge. This will be done from a putty index of the diagnostic set up.
• Incompliant and not cooperative patients.
• Patients smoking more than 10 cigarettes per day

Trial design

Primary purpose: Treatment

Allocation: Randomized

Interventional model: Parallel Assignment

Masking: None (Open label)

---

40 participants in 2 patient groups

CM LOC attachment group

Experimental group

Description:

this group will receive CM LOC attachment and lower overdenture attached to it

Treatment:

Device: CM LOC

Ball attachment

Active Comparator group

Description:

this group will receive Ball attachment and lower overdenture attached to it

Treatment:

Device: ball attachment