Status and phase
Conditions
Treatments
About
This study seeks to test the recently discovered anti-inflammatory action of statins on inflamed mucosa surrounding dental implants.
Hypothesis: The application of 1.2% simvastatin gel will decrease peri-implant inflammation.
The pilot study will involve 44 subjects divided into a test and control group. The test group shall receive topical simvastatin gel administered around the implant with a blunt tipped needle. The control group will receive a placebo.
Inflammatory state shall be determined at baseline as well as follow up visits at 24 hours, 1 week, and 1 month by clinical indices of inflammation as well as biochemical markers of inflammation gathered from around the implants.
Full description
Following signing the consent document the following will occur:
Screening Patients will complete standard medical and dental health history forms, followed by a study specific screening questionnaire. if the patient is deemed eligible, the patient will be examined clinically. The clinical examination will include diagnostic procedures typical of an implant recall visit. Initially, the sulcus will be probed with a periodontal probe; if bleeding on probing is elicited, then a radiograph will be made.
The following shall be done to screen the patients:
If the patient exhibits no bleeding on probing, or signs of mesial/distal bone loss greater than 1mm from the accepted reference point on the implant system the patient will be excluded from the study.
Subject allocation
Subjects will be assigned with equal allocation into the following groups:
Baseline measurements Baseline measurements will be made at least 48 hours after screening (allowing time for complete hemostasis of peri-implant crevicular mucosa after bleeding induced by probing in the screening visit).
Following baseline measurements, Test and Control interventions will be administered.
The baseline measurements include the following:
Peri-implant crevicular fluid (PICF) collection: Each implant site will be isolated with cotton rolls and light air will be applied over the side to eliminate ambient salivary contamination of the PICF sample. Sampling will be done using paper strips that are inserted with cotton forceps into the gingival crevice until mild resistance is felt. After gingival crevicular fluid (GCF) collection, the volumes are immediately quantified using the Periotron 8000 instrument.
Gingival Index: Using the Gingival index by Loe and Sillness 1963, the inflammatory state of the buccal, lingual, mesial and distal surfaces of the gingiva will be scored using the following score system:
0= normal gingival without signs of inflammation, no inflammation, no bleeding
Probing depth: Measured by a calibrated periodontal probe at 6 different locations, mesiobuccal, midbuccal, distobuccal, distolingual, midlingual, and mesiolingual.
Administration of test and control intervention will be delivered into the peri- implant gingival sulcus using a plastic syringe with a blunt cannula following baseline measurements. 0.1ml of gel will be administered with a blunt cannula evenly distributed in the peri-implant sulcus. The investigator will not know whether the subject is receiving the active or control intervention.
Recall appointments and measurements Both Test and Control subjects will be scheduled recall visits. Recalls will be done at 24 hours (+ or - 3 hours), 1 week (+ or - 12 hours), and 1 month (+ or - 11 days).
On each recall visit, the following procedures will take place:
Cytokine analysis Due to study constraints, not all PICF samples collected from subjects will be analyzed in the pilot study. The samples that will be analyzed will be selected randomly from the study population. Cytokine samples from only 13 randomly selected subjects from the test group, as well as 13 randomly selected subjects from the control group will be analyzed. Of these randomly selected samples, only those collected at baseline, 24 hours, and at 1 week will be analyzed. The remaining cytokine samples will be evaluated as part of a later study. Cytokine quantities will be determined using; a commercial 22 multipixed fluorescent bead based immunoassay and luminex 100 IS instrument. The kit used is the MILLIPLEX map Human Cytokine/ Chemokine Magnetic Bead Panel- Immunology Multiplex Assay (HCYTOMAG-60K) capable of detecting IL-1Beta;, TNF-Alpha;, IL-6, IL-8.
The study in total will take 1 month and 2 days. All visits will generally take 0.5-1.5 hours. No long term follow up will be required.
Enrollment
Sex
Ages
Volunteers
Inclusion criteria
Exclusion criteria
Primary purpose
Allocation
Interventional model
Masking
46 participants in 2 patient groups, including a placebo group
Loading...
Data sourced from clinicaltrials.gov
Clinical trials
Research sites
Resources
Legal